The function of the submersible pump is to pump water from the well to the surface. It is a hermetically sealed centrifugal pump with oil-filled motor. The pump is submerged in water and is driven by an electric motor.
What are the precautions when installing the submersible pump?
What is the definition of the submersible pump?
What are the precautions for using a submersible pump?
What are the precautions when installing the submersible pump?
The steps of installation on site, when the submersible pump is transported separately: A. Before installation, place the motor vertically, open the air opening and the water injection opening, be sure to open both water plugs, fill water and tighten them tightly to the water injection plug and the water drain plug. Watch for water leaking in the engine. If water leaks, do not go into the well. The reason may be in bumps during transport. You should contact the representative or manufacturer to negotiate and resolve the problem until there are no more leaks (observe for 10 to 15 minutes). Then shake the insulation resistance of the motor and its value is no less than 50 megaohm. B. Wrap the cable connector and try steering the motor after winding. Check that the steering of the motor points in the same direction as the arrow marked on the water pump and make a continuous marking.
What is the definition of the submersible pump?
A submersible pump is a type of water pump designed to be immersed in water. submersible pumps are usually used to drain or supply water in areas where the water level is below the earth's surface.
One advantage of using a submersible pump over other pump types is that it does not need a suction jack to work. This means submersible pumps can be used in areas where the water level is too low for a conventional pump to work effectively.
submersible pumps come in many different designs, but they all have one common feature: they have a hermetically sealed motor that helps keep the inner parts of the pump dry and corrosion-free.
What are the precautions for using a submersible pump?
Before the submersible pump is stopped. To prevent water reflux. Close the valve at the same time as turning off the power supply. More than 20 minutes between reboots.
2.The water outlet pipe should not be bent as much as possible, and the break of the water pipe should be found and repaired in time to reduce the power loss.
3.A filter should be added when pumping water from a water source with more dirt.
4.Before starting, correct the plus and minus poles of the power supply to prevent the water pump from reversing and no water flowing.
5.If any abnormal situation is detected during use, cut off the power supply in time and continue working after the situation is resolved.
Qiantao Pump Industry currently has more than 1,000 products, including surface pumps, deep well pumps, motors, air compressors, many product lines and complete series.
